Builders Clean Task List

1. The object of this clean is to leave the building, its fixtures and fittings and all surfaces free from dirt, extraneous and deleterious materials and in a habitable condition prior to final snagging.
2. Cleaning will be started at the top floor and worked down.

Windows Internally

3. Completely remove all paint and putty/mastic, protective paper and any other material and wash glass and frames to remove grit dirt and stains.
4. Remove all tape and shrink wrapping.
5. Wash thoroughly with detergent and water, dry and polish.
6. Remove labels from glass, wash and blade dry.

WALLS

7. Spot clean by removing all dirt marks, dust etc. from all walls.

Glossed/Stained Timber Work

8. All timberwork is to be wiped over to take off any dirty marks. All architrave’s (including tops), skirting, staircases and wardrobes are to be dusted off and polished.
10. Particular attention to be given to all windows boards and flat surfaces.

Electrical Fittings

11. Spot clean by removing all paint, plaster and other marks from switches, light pendants and other electrical fittings / accessories and polish wipe clean.

STAIRS

13. Scrape off any mud/plaster, sweep thoroughly and lightly mop down.
14. Fully clean between all balustrades and spindles.

Kitchen/Utility area

15. Remove dirt from tops of wall units and cupboards.
16. Remove all protective coverings and cellotape, sweep/dust out all cupboards, spray and wipe clean, open all drawers and spray wipe clean.
17. Clean all doors and handles, clean worktops, remove paint spots, dry and polish. Sink tops,
taps, damp cleaned, then dried and polished. 18. Clean all white goods/oven/hob etc, where applicable.

Boiler cases and electrical appliances must be cleaned externally, removing dust from all crevices leaving in a polished state.

Bathrooms/En-suites/WC

20. Thoroughly soak, remove labels and coverings from sanitary ware. Remove all paint, plaster, clean and polish.
21. No abrasive powders or polishes to be used on plastic baths or other acrylic products.
22. Baths, shower trays, taps and shower units, should have all packaging removed, any paint etc., spot cleaned and finally be cleaned and polished.
23. Polish all shower screens and wall

Floor Areas

25. Remove protective floor covering and tape where necessary.
26. Concrete or screeded areas should be scraped of all mud, plaster, cement etc. and thoroughly swept. All areas should be lightly mopped.
27. Kitchen vinyl, tiled and laminated floor areas should be cleaned of mud, swept and mopped using quality detergent, dry and polish, ensuring smearing of dust and dirt does not occur.

Tiled Floors

28. Sweep and wash over, using a minimum amount of water, ensuring smearing of dust and dirt does not occur.